Features Tailor made for SEAT IBIZA MK5 KJ 5-doors 2017-onwards Hatchback ISPEED wind deflector has many capabilities such as preventing rain from entering whilst window is slightly down, disperses cigarette smoke, reduces air turbulence so there is less noise when driving on motorways and many more Sleek aerodynamic look, no unsightly exterior tape ,can be painted DARK TINTED - This helps reduce solar irradiation and provide UV protection stopping sunlight from disrupting the driver's field of vision Made from tough acrylic plastic OEM Quality ISO 9001 and TUV Approved Mounting parts included Car wash safe Optically transparent Product DescriptionFITTING INSTRUCTIONS FOR ELECTRIC WINDOWS WITH ANTI TRAP DEVICE 1: Take care â some edges and corners of the deflector can be sharp. Please take care when removing from the box and fitting. 2: Open the window completely 3: Lubricate the milled edge of the deflector with either a silicone spray or washing up fluid. 4: At the mirror end of the window rest the bottom edge of the deflector on the hard rubber window seal. 5: If you place it on the soft part of the rubber the deflector will not hold under tension. 6: Push the other end of the deflector into the window channel â you may need to gently bend the deflector. 7: Starting from the mirror end use both hands to ease the milled edge of the deflector into the rest of the window channel not between the rubber and the metal frame. 8: Close the window in several small steps â assist with your hand if need be.. 9: fit 2 clips each side, check where the window is making the most resistance and fit the clip near that position. AFTER FITTING THE WIND DEFLECTORS ACCORDING TO THE FITTING INSTRUCTIONS, PLEASE CONSIDER THE FOLLOWING POINTS 1: Operate the electric window button and close the window gradually in several small : Then operate the electric window button and slowly close the window completely. 3: After this please keep the door window closed for 24 hours so that the wind deflector is pressed into the rubber by the permanent pressure of the glass. 4: After being closed for 24 hours the electric windows will work correctly. 5: Rear deflectors must be fitted at an angle into the window channel, once both ends are inside the window channel, slide the lower end to its position and secure with metal clips.